Valor Fires 870 hydroflame Dream, Инструкция для установщика и владельца

Страница: 13 / 28

Although this section deals with fireplace openings without a spacer, this method of
securing the heater can also be used with the optional spacer frame kit (See method
C).
1.
The fixing kit supplied with the heater
includes a steel wire and eye screw. These
can be used to secure the heater to the back
of a surround / fireplace opening.
2.
Mark the eye screw position on the centre
line at the back of the fireplace opening and at
a height of 565 - 575mm (See figure 6).
3.
Drill an appropriate size hole in the marked
position.
4.
Insert a wall plug into the drilled hole.
5.
Screw the eye screw into the wall plug.
6.
Connect the heater to the fused spur.
7.
At the top of the heater there are four small
holes, two each side of the heater. From the
front of the heater, thread about 50mm of the steel wire into the outside small hole on
the right side of the heater (See point 1 - figure 7).
8.
Thread the other end of the wire through the remaining small hole to the left.
Continue to push the wire through this hole until there is only a small loop of wire at
the front of the heater (See point 2 - figure 7).
9.
At the back of the heater there will be a long piece and a short piece of wire
coming through the two holes. Hold the short piece and give the long piece a gentle
tug. This will secure the steel wire. Take the long piece and thread this through the
eye screw in the back of the fireplace opening (See figure 7).
10.
From the back of the heater thread
the long piece of steel wire through the
inner small hole on the left hand side of
the heater (See figure 7).
11.
Locate the heater in the fireplace
opening, then from the front of the
heater, gently pull the steel wire on the
right hand side to gather up the excess
until the heater is secure. Thread the
wire through the remaining small hole
to lock the wire and heater in place
(See point 4 - figure 7).
Page 13
©
Baxi Heating U.K. Limited 2009.
INSTALLER GUIDE
Figure 6. Eye screw location
Figure 7. Wire fix