Q
Do you want to fit the heater against a flat wall with the base of the heater on
a hearth or similar surface?
A
You will need to purchase the optional spacer frame kit (kit number
0584081).
This
spacer when added to the one supplied with the heater enables the heater to be
flat wall fixed.
The depth of the combined spacer frames is 145mm.
Q
Do you want to wall mount the heater against a flat wall?
A
You will need to purchase the
Optional spacer frame kit
(kit number
0584081)
and an
Elevated installation kit
(kit number
0584091).
The optional spacer when
added to the one supplied with the heater covers the full depth of the heater rear
(
145mm).
General notes to read before fitting
your heater.
There should be at least 50mm clearance between
the top of the fascia and anything such as a shelf,
fireplace surround or mantel etc. This will allow the
fascia to be lifted off or removed during servicing.
To check the shelf clearance gently place the
fascia against the surface to which it is to be fixed
and measure the distance from the top of the
fascia.
If fitting the heater onto a reflective or shiny
surface such as a hearth we recommend that
this surface does not extend further than 300mm
from the fixing plane (wall). Reflective or shiny
surfaces that project further than 300mm may
reflect an image of the internal lamp.
Fitting the cable clamp.
If the mains cable is to be routed to the left hand
side of the heater there is a cable clamp supplied
with the heater to hold the cable in place. This
prevents the cable being trapped under the
heater during installation. Fit the cable clamp as
in figure 1.
Checking the lamp.
When handling the lamp avoid touching the glass
with bare fingers as this will reduce the life of the
lamp.
Before continuing with the installation of the
Page 8
INSTALLER AND OWNER GUIDE
©
Baxi Heating U.K. Limited 2008.
Figure 2. Checking the lamp
Figure 1. Fitting the cable clamp
Содержание 842
Страница 25: ...Baxi Heating U K Limited 2008...