3.
Lift the glass panel clear of its
lower support channels (See figure
11). Lower and remove the glass
panel. Place the glass panel in a safe
place away from the work area.
4.
Detach the burner unit from the
convection box by removing two
screws (See figure 12). Lift the burner
unit clear.
5.
Fit the two “U” section seals to the
bottom edges of the convection box
side flanges (See figure 13).
6.
It is important that the grommet
supplied in the loose parts pack is
fitted to the hole in the rear of
the convection box.
7.
For concealed connection only:
Pierce the grommet to allow the
pipe to pass through it. The
grommet should envelop the pipe.
If the hole is larger than the pipe,
seal it with tape.
Do not pierce
the grommet unless the supply
pipe is to pass through it
.
©
Baxi Heating U.K. Limited 2008.
Page 21
Figure 13. ‘U’ Seals
Figure 12. Burner attachment points
INSTALLER GUIDE
Figure 11. Window removal
