Valor Fires 752, Инструкция для установщика и владельца

Страница: 23 / 49

6. Thread the cables through the eyebolts. Return the
cables through the holes near the bottom of the hotbox
side panels (See figure 13).
7. Place the hotbox fully back into the fireplace opening
so that it is sealed against the fireplace front surround.
8. Fit a cable retainer over the bottom end of each cable.
9. Pull each cable taut. Push the cable retainers hard up
against the back panel. The end of the cable adjuster
will pass into the hole. Tighten the screws in the
retainers so that they clamp the cables in position. Apply
tension to the cables by turning the hexagonal adjusters
by hand. (See figure 14).
10. Inspect the installation of the hotbox against the
fireplace surround. If the hotbox
is aligned squarely and the
sealing is satisfactory, fully
tighten the cable retainers.
11. If the hotbox is not correctly
aligned, release the tension on
the cables by slackening the
screws and turning the hexagonal
adjusters fully anticlockwise. The
hotbox should then automatically
realign itself. Pull each cable taut
again and push the cable
retainers back against the back panel. Again, tighten
the screws in the retainers and apply tension to the
cables by turning the hexagonal adjusters clockwise
as far as possible.
12. Do not cut off any excess cable, instead coil up
the cable so that they are available to allow easy
removal and refitting of the appliance during
subsequent service calls.
9.2 Floor sealing (All Installations).
Using the floor sealing tape supplied, seal the bottom
of the hotbox to the fireplace and hearth floor. Run
the tape round the front edge of the wall. We
recommend that the tape go no further than 8mm
down the front face of the wall as it may be visible
under the base of the fascia. This will depend on the
height of the installation (See figure 15).
Pa ge 2 2
INSTALLER GUIDE
©
Baxi Heating U.K. Limited 2007.
Figure 15. Floor sealing
Figure 14. Lower cable retention
Figure 13. Cable route