Valor Fires 347 Brava 4 Oxysafe, Инструкция по установке и эксплуатации

Страница: 35 / 44

To light the fire (Electronic ignition).
The control is shown in figure 2.

Depress the control knob slightly and turn
anticlockwise towards the 1/IGN position. Do
not apply too much pressure as this will cause
resistance to be felt. Depress the control knob.
Sparks should be generated at the pilot. The
sparks should ignite the pilot. If the pilot does
not light, turn the control knob back to the‘OFF’
position and try again. The pilot flame can be
seen through the opening immediately below
the right hand centre radiant (See figure 3).
If no sparks are generated at the pilot the
battery may have no power. The battery can
be replaced as shown later in this guide.
In the unlikely event of failure of the ignition
mechanism or where a replacement battery is
not available the pilot can be lit with a long
match or taper – See next page.

When the pilot has lit keep the control
knob depressed for about ten seconds to
allow the flame sensing probe to warm up.

The control control knob can then be set to your preferred heat level. The
settings are: -
To turn off partially depress the knob and turn clockwise to off. Wait at least three
minutes before attempting to relight.
Page 35
©
Baxi Heating U.K. Limited 2008.
Figure 3.
Control Knob
Position
Radiants Condition
2
Centre radiants on low. Outer radiants off.
(The right hand centre radiant will glow slightly
more than than the left hand centre radiant due
to the pilot flame)
3 Centre radiants fully on. Outer radiants off.
4 Centre radiants fully on. Outer radiants on low.
5 All radiants fully on.
OWNER GUIDE