Valor Fires 347 Brava 4 Oxysafe, Инструкция по установке и эксплуатации

Страница: 28 / 44

the radiant box (See figure 17).
11.6.6. Remove the pipes, gas tap or
injectors as required.
11.6.7. Replace in the reverse order.
Take care when replacing the injectors.
The injectors have ceramic tips at each
end. It is important not to allow jointing
compound to get on either end of the
injectors.
Make sure that the control knob with
spindle is correctly turned to agree with
the gas tap position before refitting the
split pin.
11.7 To grease the gas tap
11.7.1. Remove the burner module as
section 11.6.
11.7.2. Remove the circlip holding the piezo generator to the tap and remove the
piezo generator.
11.7.3. Remove the two screws from the head of the gas tap and remove the gas tap
head.
11.7.4. Remove the spindle and spring from the tap.
11.7.5. Note the position of the slot in the plug. Mark this position on the tap body.
11.7.6. Rotate the plug and pull it out of the tap.
11.7.7. Clean and grease the plug lightly with suitable grease. Do not apply excessive
grease. Particularly, make sure that the gas ports are not restricted by grease.
11.7.8. Push the plug back into the tap body. Line up the slot in the plug with the
mark previously made on the tap body.
11.7.9. Reassemble in the reverse order making sure that the components are
correctly engaged. Check the operation of the tap and ignition. Make sure that the
control knob with spindle is correctly turned to agree with the gas tap position before
refitting the split pin / ‘R’ clip.
Page 28
©
Baxi Heating U.K. Limited 2008.
Figure 17. Burner module removal
INSTALLER GUIDE