Valleylab SurgiStat II-20, Руководство пользователя

Страница: 44 / 68

General Troubleshooting Guidelines
6-2 SurgiStat II-20 User’s Guide
General Troubleshooting Guidelines
The SurgiStat II includes automatic self-diagnostics. If the diagnostics detect an
error, the system displays an error code, sounds an audible tone, and deactivates
the unit output power.
Correcting Malfunctions
Most error codes result from faults in accessories attached to the unit. The
following table lists the error codes, describes the error, and recommends actions
to take to resolve the error.
Error Code Description Recommended Action
F1 (on the
Cut/Blend
Display)
F1 (on the
Desiccate/
Fulgurate/
Bipolar
display)
Handswitch or monopolar footswitch
cut pedal may be stuck
Handswitch or monopolar footswitch
coag pedal may be stuck
1. Turn off, then turn on the generator. Do not press
buttons or accessory activation devices during the self-
test.
2. If the alarm number reappears, disconnect all
accessories. Turn off, then turn on the generator again.
3. If the problem persists, replace the handpiece or
footswitch and repeat Step 1.
4. If the alarm number reappears, record the number and
call the Valleylab Service Center.
F2 Cut and Coag buttons activated
simultaneously (pencil or footswitch) The unit does not allow simultaneous activation of the cut
and coagulation modes. Release either the cut or coag
button on the handpiece, or the cut or coag pedal on the
footswitch.
F3 Monopolar handpiece activated while
in Bipolar mode Release pressure on the handpiece buttons. Use the
footswitch to activate Bipolar, or switch to Monopolar
mode.
E4 Line voltage error (Line voltage too
high) 1. Turn the unit off.
2. Verify that the unit is connected to the correct line
voltage.