Valley Sportsman 8725657, Руководство пользователя

Страница: 12 / 35

13
Once the base is assembled, attach the Drive Belt to the motor wheel (A) and to the Spindle Wheel
(B) in the compartment directly above. If the two wheels
don’t line up properly, loosen the four bolts
(C) holding the motor in place and slide the motor up or down, depending on need.
Once the wheels line up, retighten the bolts. (Figure 2)
steps.
Turning the nut (H) counterclockwise lowers and decreases tension on the Drive
Wheel (I) allowing you to adjust the alignment of the blade or to replace the blade
entirely. (Figure 6)
To center the blade on the wheel, loosen the two nuts (J) until the blade centers
onto the Drive Wheel, and then retighten the nuts. Turning the wheel by hand
makes moving the blade easier. Adjust the socket screw (K) to increase or
decrease the angle on the Drive Wheel, helping center the blade on the wheel.
Once the top part of the blade is set, the bottom will need adjustment. First,
loosen the two socket screws to adjust the Guide Plates (L), making sure there is
at least 1/32" space between the edges of the guide plates and saw blade (M)
(Figure 7).
Replacing and Adjusting Saw Blade
WARNING