background image

4.4.1 General

Ensure that sufficient space is available for handling and placement of the modules. Do not place 
the VALEN ENLiFEN Batteries near a source of heat, in direct sunlight or where the module may be 
subject to condensation or water spray. When connected, check the battery voltage. Check the cell 
voltages and record them with the module ID. 

4.5 Electrical Connections

Proper battery electrical connections are very important for the best battery performance and 
utility. Improper battery connections can cause a loss of standby time or even a battery fire. Follow 
the electrical connection instructions carefully and review section 1 thoroughly before working on 
the battery. Make sure that all terminals and interconnects are clean and connecting bolts are tight. 
Ensure all plugs, especially the ones carrying the main power, are securely plugged in and these are 
not under stress which could cause them to come loose at a later date. 

4.5.1 Cabling Recommendations

Battery ratings are specified at the terminals of the battery. The cabling used to connect the battery 
terminals to the load has a voltage drop (when the battery is discharging) that is dependent on 
cable length and conductor size. The longer the cable run, the greater the voltage drops. The smaller 
the cable wire diameter, the greater the voltage drop. Therefore, to get the best performance from 
the battery short, heavy cables are recommended. Do not size the cables based on current-carrying 
capacity only. A general rule of thumb is to allow no more than a 20-30mV of voltage drop/metre of 
the cable run. As an example, if it is 10m from the battery to the load, the cable should be sized to 
allow no more than 2 x 10 x .030 = 0.6 V volt drop. To help select cable sizes for load connections, 
the following table should be consulted: 

US CABLE SIZE

MM

2

Max. Amps 30mV Drop/M

8 AWG

8.4

15

6

13.3

23

4

21.2

37

2

33.6

59

1

42.4

74

0

53.5

93

00

67.4

117

000

85.0

148

0000

107.2

187

250MCM

126.7

221

350MCM

177.4

309

400MCM

202.4

353

Use 1.74 amps/mm

for other cable sizes

6

AUS

 

[email protected]    NZ  [email protected]

Содержание ENLiFEN











Отзывы: