Valcourt FG00001, Руководство по установке

Страница: 51 / 62

Page 51 Installation Manual - L48
ENGLISH
Notice: The glass door is secured
to the top of the firebox with
tabs that allow the glass door to
pivot outward at the bottom. The
bottom of the door frame engages
into the four bullet type retainers.
C
DETAIL C
7.2 Glass Placement
7.2.1 Preparation of fireplace
NOTE : The optional variable halogen lighting is available. If used, follow instructions of the manual.
CAUTION
Turn off all power to the fireplace prior to changing bulbs or servicing the controls.
If a liner kit has not been installed, STOP and install one before proceeding with media placement.
1. Remove the light cover and verify that the variable halogen lighting bulbs are installed in the light
bracket. These are located in the reflective light bracket at the front of the firebox. Use gloves or a
soft cloth to verify the light bulbs are plugged correctly. Do not handle halogen bulbs with your bare
hands. Oils from your skin will cause the bulb to burn out prematurely.
2. Install the two accent glass panels into the metal retainer bracket located above the lights.
The two glass panels will be placed so they meet together at the center of the bracket.
3. Replace the light cover over the lights.
4. If applicable, install logs and rock kit.
5. Add the decorative crushed glass media of your choice at this time. Crushed glass may cover the
complete burner cover, accent glass panels, and burner screen.
Place crushed glass media over the burner screen in a single layer. Use just enough crushed glass media
to mask the burner screen (approximately 1 sq. ft.). Use up to (5 sq. ft. of 1/4 inch) crushed glass over
the burner cover and variable halogen lighting glass panels.
NOTICE:
• 1/4 inch crushed glass media is required on the burner screen and accent glass panels.
• 1/4 inch crushed glass media is optional on the burner cover or light cover (if the variable halogen
lighting is not installed.)