Valcom V-WMCA, Инструкция по эксплуатации

Страница: 34 / 34

Valcom Master Clock
(V2)
Page 34
Troubleshooting
The master clock will not power up. What do I do?
Make sure the power cord is securely connected to the power outlet and to the back of the Valcom Master
Clock. Upon being connected to power, the master clock should boot up instantly. There is not an on/off
switch.
What do I do if I cannot connect to the browser?
Verify that the IP address your attempting to access is correct. If the IP address is correct, verify that there
aren’t any provisions in the firewall preventing you from accessing it. If all else fails, try connecting via a cross-
over cable.
What do I do if the GPS isn’t receiving a signal?
Check the antenna to make sure it is in an unobstructed area that is in complete view of the sky. Also, check
to make sure the connections on each end of the cable are securely tightened. Lastly, verify that there are no
kinks or breaks in the supplied GPS cable.
My sync-wire system doesn’t seem to be getting the correct time. What should I do?
The clock 1 and clock 2 outputs control the sync-wire systems. Verify that the correct system is set for the des-
ignated clock circuit. Protocol details are listed on page 18.
Why didn’t my Valcom Master Clock change for Daylight Savings Time?
A few things could cause the Valcom Master Clock not to change for Daylight Savings Time. The first item to
check is the date to verify if it’s correct. If the date is not correct, the clock will not change. If the date is cor-
rect, verify that the clock is set for the correct version of Daylight Savings Time. See page 14 for more infor-
mation.