Valcom V-GPS-TX, Инструкция по эксплуатации

Страница: 26 / 34

Valcom Master Clock
(V2)
Page 26
System Settings Page 2
Web Browser Programming
Input Selection - This drop-down list allows the user to select which input will control the master clock. The choices
are:

Real Time Clock • 58 Minute Sync_3

GPS • 58 Minute Sync_4
 SNTP • National Time_Rauland

59 Minute Sync • Dukane Digital

58 Minute Sync_1 • Rauland Digital
 58 Minute Sync_2 • Once a Day Pulse
If Once a Day Pulse is selected, then fields for hours, minutes and seconds will appear. Enter the time (in 24 hour
mode) that the clock is to go to when a once a day pulse is present. It must be a minimum of a two second pulse.
Backup Selection - This drop-down list allows the user to select a backup input in case of the loss of the primary in-
put. In order to use the Backup Selection, the following protocols cannot be used as both a primary and secondary
input: 59 minute sync, 58 minute 1-4 sync, National Time/Rauland, Dukane Digital, Rauland Digital and once a
day Pulse. An example of a configuration would be SNTP being the primary input and 58 minute correction being a
secondary input. Setting the primary source to 59 minute sync and the secondary source to Dukane digital would
be an incorrect configuration.
Clock #1 Circuit - This drop-down list allows the user to select the sync-wire output for the Clock #1 circuit. The
choices are:

59 Minute Sync* • 58 Minute Sync_4*
 58 Minute Sync_1* • National Time_Rauland_1*

58 Minute Sync_2* • National Time_Rauland_2*

58 Minute Sync_3*
Clock #2 Circuit - This drop-down list allows the user to select the sync-wire output for the Clock #2 circuit. See #3
above for the list of choices.
Reset All Settings to Default - This button, when pressed, will revert all settings back to the default settings that were
sent from the factory.
Submit - This button, when pressed, will save all of the information to the master clock.
Cancel - This button, when pressed, will clear out any changes made and will not save any data.
Menu - This button, when pressed, will bring the user back to the main menu.
1
2
3
4
5
6
7
8
* See page 18 for protocol definitions