27
947180
3. Enter
0
(NONE),
1
(AA, Attendant Access), or
2
(T/R, Telephone Access) to select the audio source
(or none) to be enabled when this zone is activated.
Hear TRIPLE beeps.
4. To verify your selection, Dial
9 7
and repeat steps 2 and 3, above.
9 8 SET AUDIO ROUTING
If optioned, whenever a selected input zone with “Audio Source Enabled” is active, the audio source
(either Telephone Access or Attendant Access) will be routed to the selected zone or group. The default
for this parameter is NO ZONES.
Door Service
The primary use for this feature is to allow the paging system to be used for door service. For example,
you have optioned the doorbell input zone to enable Telephone Access, and you wish now to select the
door speaker to be the output zone for this Telephone Access audio.
The audio path will remain routed for 10 seconds. If the user accesses the controller during the 10 sec-
ond period, they will automatically be routed to the zone specified in this procedure. If the user accesses
the controller after the time expires, the user will receive a dial tone.
Note:
If a Connect password has been installed in your system, you will have to access the paging sys-
tem and enter your password, before being automatically routed to the zone.
If the doorbell input has a higher priority than the telephone access and is activated while telephone
access paging is underway, then you will receive the tone specified in the option Tone Selection, above,
and then will be automatically routed to the proper zone.
1. Dial
9 8
to select Audio Routing.
Hear DOUBLE beeps.
2. Enter the input zone or group zone number.
Hear DOUBLE beeps.
3. Enter the output zone / group ALIAS number.
Hear TRIPLE beeps.
4. To verify your selection, dial
9 9
and repeat steps 2 and 3 above.
Technical Manuals Online! - http://www.tech-man.com
Technical Manuals Online! - http://www.tech-man.com
firealarmresources.com
