PAGE 6
13>TETHER STRAP
1>PARTS LIST
1x hood, 2x rear wheels, 2x front wheels,
stroller frame/seat.
2>TO OPEN
Remove the carton contents carefully.
Dispose of any packaging materials
thoughtfully .
Release the stroller from the locked
position by lifting the locking hinge from
over the locking rivet on the stroller frame.
Lift the handle upward until the frame locks
in the upright position.
IMPORTANT WARNING: ALWAYS
TEST THAT ALL LATCHES ARE
SECURELY ENGAGED BEFORE USE.
3>FRONT WHEELS
Lay the stroller on its’ back so that the handle
bar is resting on the floor. Insert the front
wheel pin by sliding it into the front wheel
mount until you hear a ‘click’. Gently pull on
the front wheel to make sure it is properly
engaged.
To remove the wheel, press the button on
the wheel casing and pull wheel gently away
from the stroller.
To swivel front wheel: raise the swivel lock
to allow the front wheel assembly to swivel.
To lock the wheels, press down on the
swivel lock to lock the front wheel assembly
in a fixed position.
IMPORTANT WARNING: ALWAYS
TEST THAT WHEELS ARE SECURELY
ENGAGED IN EACH WHEEL MOUNT BEFORE
USE.
4>REAR WHEELS
Align the rear wheel axle with the wheel
mount on the stroller frame and insert it
into the wheel mount until it ‘clicks’ into
place.
Gently pull on the rear wheel to make sure
it is properly engaged.
To remove the rear wheel, press the wheel
release button and gently slide the wheel
out of the wheel mount.
5>HOOD
To attach the hood: locate the hood
mounting joint on the frame of your stroller.
Slide the hood attachment brackets
downward onto the mount on both sides.
Secure each side of the hood to the frame
by engaging the buttonhole over the rivet
head found on the underside of the frame.
For additional ventilation, your hood is
fitted with our additional airflow system.
Simply undo the zip carefully and pull your
hood forward. To close, zipper the section
back in place being careful that the mesh
does not become caught in the zip.
6>BUMPER BAR
To attach the bumper bar, press and hold
the buttons on both sides of bumper bar
mounting and insert bumper bar end into
INSTRUCTIONS
WARNING: ALWAYS WEAR THIS STRAP TO
STOP THE PRAM/STROLLER ROLLING AWAY
DashIM_190718.indd 6
19/7/18 4:20 pm
