Vaisala WINDCAP WMT52, Руководство пользователя

Страница: 42 / 143

User’s Guide ______________________________________________________________________
40 ___________________________________________________________________M210925EN-B
are drawn by the wind sensor (whenever enabled) at 4 Hz rate, which is
the default value for wind sampling. Wind sampling at 2 Hz or 1 Hz rate
is also available (see
Chapter 8, Sensor and Data Message Settings, on
page 95 ). The average current consumption will decrease almost in
proportion to the sampling rate, since wind measurement is the most
consuming operation in the system.
In most occasions the average consumption is less than 10 mA.
Typically, the higher the voltage the lower the current (see
Figure 19 on
page 40 ).
0805-023
Figure 19 Average Operational Current Consumption (with
4Hz Wind Sensor Sampling)
Heating Voltage
Heating voltage Vh+ (one of the following three alternatives):
- 5 ... 32 VDC;
- AC, max V
peak-to-peak
84 V; or
- Full-wave rectified AC, max V
peak
42 V.