Vaisala HUMICAP HMW92, Руководство пользователя

Страница: 56 / 100

User's Guide _______________________________________________________________________
54 ___________________________________________________________________ M211399EN-G
Set Serial Line Turnaround Delay
With the
SDELAY
command you can set the turnaround delay of the
transmitter (time waited before replying to an incoming message) or view
the currently set delay value.
SDELAY
[
delay
]<cr>
where
delay = Turnaround delay in milliseconds, range 1 … 1000.
Default is 1.
Example:
> sdelay 5
COM1 transmit delay : 5
Relay Configuration in Custom Mode
NOTE Relay is included on HMW93 transmitters only.
Additional configuration options are available when relay functionality is
configured via software. The configuration is done using the RMODE
and RSEL commands. For examples, see section Relay Configuration
Examples on page 56.
Set Relay Mode
Use the RMODE command to show or set the relay activation mode.
RMODE [ mode ]<cr>
where
mode = Activation mode of the relay. Options are:
None (relay is disabled, always open)
Lo_active
(relay closed when below setpoint)
Hi_active (relay closed when above setpoint)
Fault (relay closed when transmitter in error state)
Not_fault (relay closed when transmitter not in error state)
Example (set relay to Lo_active mode):
> pass 9000
> rmode lo_active
Relay mode : Lo_Active