Vaillant sensoHOME VRT 380f, Инструкции по эксплуатации и монтажу, Страница: 18 / 108

3 -- Electrical installation, set-up
16
Operating and installation instructions sensoHOME 0020298974_00
8. Set the time.
◁
The installation assistant switches
to the
Control reception strength
function.
Condition : Wireless outdoor temperature sensor
available
▶
If a wireless outdoor temperature
sensor is available, this must be paired.
To do this, follow all of the installation
instructions in its instructions.
▶
To pair the wireless outdoor temper-
ature sensor, press the button on the
radio receiver unit. The LED flashes
green.
▶
Activate the outdoor temperature
sensor as described in its instructions.
The LED on the radio receiver unit
flashes briefly. Once the pairing pro-
cess is complete, the LED no longer
lights up.
▶
Go to the chosen installation site for the
wireless outdoor temperature sensor.
▶
If the reception strength at the chosen
installation site is < 4, find a new in-
stallation site for the outdoor temperat-
ure sensor
–
one that has a reception
strength of
≥
4.
▶
Install the outdoor temperature sensor
at the installation site.
Determining the control's installa-
tion site in the building
9. Choose an installation site that meets
the following requirements.
–
Internal wall of the main living room
–
Installation height: 1.5 m
–
Not in direct sunlight
–
Not affected by heat sources
Determining the reception strength
of the control at the chosen install-
ation site
10. Go to the chosen installation site for
the control.
11. Close all doors behind you on the way
to the installation site.
12. Press the wake-up/sleep button on
the upper side of the unit if the display
is off.
Condition : The display is on, The display shows Ra-
dio communication interrupted
▶
Make sure that the power supply is
switched on.
Condition : The display is on, Control reception
strength < 4
▶
Find an installation site for the control
that is within the reception range.
Condition : The display is on, Control reception
strength
≥
4
▶
Mark the position on the wall where the
reception strength is sufficiently high.
Attaching the unit mounting
bracket to the wall
A
B
13. Remove the unit mounting bracket
from the control as shown in the fig-
ure.
A
B
C
Ø6
14. Secure the unit mounting bracket in
accordance with the figure.