Vaillant ecoMAX SERIES, Инструкция по установке и обслуживанию

Страница: 55 / 56

55
Instructions for installation and servicing ecoMAX
55
• Turn anti–clockwise to increase level of CO
2
content.
• Turn clockwise to reduce level of CO
2
content.
• Once the adjustment procedure is complete, swivel the
air suction pipe upwards and back into position.
• Re–check the level of CO
2
content.
• The adjustment procedure may have to be repeated.
• Press the ”+” and ”–” buttons simultaneously to deac-
ti–vate full gas rate mode. Measurement mode is also
cancelled if no control button is operated for 15 minutes.
• Reposition air suction pipe and tighten screw (4).
• Raise control panel.
Adjustment Natural gas (H) Propane Unit
settings Tolerance Tolerance
CO2 after 5 min. 9,0
±
1,0 10,0
±
0,5 Vol.–%
operation at full load
Adjusted for 15 22,5 kWh/m3
Wobbe index Wo
Tab. 9.2 Factory–adjusted gas settings
Fig. 9.12 Carrying out measurement of CO
2
levels, preparing for
air–ratio adjustment
Fig. 9.13 Carrying out air–ratio adjustment (gas supply settings)
10. Recycling and eventual scrapping
The design of all Vaillant products takes into account
the subsequent recycling and/or eventual safe scrapping
of each component used. Vaillant’s in–house rules set
strict standards in this respect. The selection process
used for choosing raw materials includes full considera-
tion of their recycling characteristics, and of the break-
down and separation properties of subassemblies. We
also take fully into account the environmental and
health hazards involved in recycling and in the disposal
of non–reusable waste items.
10.1 The appliance
The Vaillant ecoMAX consists largely (92 %) of metal
components designed for eventual recycling by incorpo-
ration into the smelting process of a steelworks. This
gives these parts virtually unlimited scope for subse-
quent re–use. All plastic materials are duly identified to
facilitate sorting and separation when the time comes to
recycle the unit.
10.2 Packing
Vaillant endeavours to keep the amount of transport
packaging used for its equipment to the bare minimum
necessary. Subsequent re–use is taken into account
when selecting packaging materials. High–quality card-
board has long been a valuable secondary raw material
for the card and paper industry. The sections of EPS
(Styropor®) are required in order to protect equipment
in transit. EPS is 100 % recyclable and CFC–free. The
foil–wrapping and securing straps are likewise made of
recyclable plastic.
6
3
4
5
6
Recycling and eventual scrapping 10
83 41 77_12 GB04.04.qxd 22.09.2004 12:34 Uhr Seite 55