Vaderstad E-services, Инструкция по эксплуатации

Страница: 27 / 48

Calibration
7.5 Oil flow
It is important to calibrate the oil flow to make
sure that you do not drive with either too high or
too low a flow.
In order to determine the appropriate oil flow at the
desired driving speed, the oil flow can be calibrated.
Figure 7.5
A. Maximum speed for seed output with the set torsion
test (limited by the lowest speed for C , D and E)
B. Oil flow at maximum speed.
C. Set torsion test parameters for seed and speed limit.
D. Set torsion test parameters for BioDrill and speed
limit.
E. Set torsion test parameters for fertiliser and speed
limit.
7.5.1 Calibration procedure
Torsion tests for seed, fertiliser and BioDrill are
to be conducted prior to starting the calibration
of the oil flow.
Figure 7.6
• Green numbers show the values from the torsion tests.
• Red numbers indicate that the values from the torsion
tests are missing.
1. Turn off the hydraulic outlet for feed output on the
tractor.
2. Mechanically activate the left and right half machine
shut-offs on the machine in order to prevent feed
output during the calibration of the oil flow.
Figure 7.7
3. Confirm that the half machine shut-off has been
activated by clicking in boxes (A) and (B) in the pop-
up window that is displayed.
Figure 7.8
4. Turn on the hydraulic connection for feed output in
the tractor and adjust the flow until the desired
maximum speed is reached.
903099-en-gb; 19.01.2021 23