Vaderstad CR 925, Инструкция по эксплуатации

Страница: 36 / 58

Use of the machine
8.3 Straw harrow
8.3.1 Switching between the working position and
transport position
To reduce the transport height of the implement,
the straw harrow’s wing sections must be folded
together before the implement is switched to the
transport position.
Figure 8.4
1. Remove the pins.
Figure 8.5
2. Fold in the front pin shaft towards to the rear shaft.
3. Fix the straw harrow into the retracted position by
replacing the pins.
Folding out to the working position is undertaken in
reverse sequence.
8.4 Setting the depth stopper
Figure 8.6
The machine is fitted with a depth stop that enables the
front tool to return to the set working depth when lowered
again; for example after turning on the headland.
Figure 8.7
The depth stopper is connected to a 12V electrical outlet
on the tractor.
Adjust as follows:
1. Loosen the knob.
2. Move indicator (A) back to an approximate position
(B).
3. Set the hydraulics to the desired operating depth
while driving.
4. Move the indicator (A) forwards so that the limit
switch (C) is activated.
5. Tighten the knob.
The front tool will then return to the set working depth
following each lifting/lowering sequence.
C
B
A
32 903815-en-gb; 23.09.2021