WideSHOT WallVIEW Mini
WideSHOT WallVIEW Mini, Document Number 342-0710 Rev A
Page 11 of 32
Diagram: Basic System Configuration WideSHOT with USB Mini
W
IDE
SHOT
C
AMERA
-
F
IRST
T
IME
S
ET
-
UP
The WideSHOT was designed to be very easy to use and operate. There is
documentation at the back of this manual for pin-outs for the connectors on the
WideSHOT camera and the USB Mini Interface.
Before Installing the Camera:
Choose the camera mounting location while paying close attention to camera
viewing angles, lighting conditions, possible line of site obstructions and
checking for in-wall obstructions where the camera is to be mounted. Always
pick a mounting location that will optimize the performance of the camera.
Please locate the camera to enable easy positioning of the camera body with
the ability to point down and away from the ceiling and a bunch of fluorescent
lighting cells.
Cameras generally don’t like to be swamped with fluorescent
light and very few people sit on the ceiling anyway
.
The Thin Profile Wall Mount for the WideSHOT can be mounted directly to a 1-gang wall box or can be
mounted using two (2) provided spiral dry wall anchors.
For Power/Video and RS-232 signals, use standard Cat-5 cable (568B termination and real RJ-45
connectors) from the EZ-POWER VIDEO and RS-232 ports on the back of the WideSHOT to the Quick-
Connect USB Interface. The EZ-POWER VIDEO jack on the camera is marked in
red
as a reminder that
there is 24 VDC power on that Cat-5 cable.
Image:
WideSHOT HD
Camera with provided
Thin Profile Wall Mount
Local
Power
24 VDC
USB 2.0
Connected
to Front
Panel
Serial Control (RS-232)
◄
HD
Video from Camera - Power to Camera
▶
Laptop with UC
Application
Room Monitor
(Simulated video feed)
HD Video
(HDMI, DVI
or RGBHV)
Quick-Connect USB Mini
Rear Panel (above), Front Panel (below)
Two (2) Cat-5 Cables
Distance up to 150’ (15.26m)
WideSHOT HD
Camera
USB 2.0
(UVC
Drivers)
Extension of PC Video
to Room Monitor
