WallVIEW 50i HideAway – Document 341-141 Rev. C
Page 7 of 14
16. After the initial power up, the WallVIEW 50i PTZ HideAway can
be opened and closed with the supplied Canon WL-V5 IR
Remote controller or by the ON/OFF RS-232C commands on
page 9. To open and close the camera with the IR Remote,
press the on/off button marked in green (see Figure 8).
17. The installation of the Vaddio WallVIEW 50i PTZ HideAway is
now complete. With a soft cloth, please dust the exposed
surfaces of the product (avoid the camera lens) to remove any
sheetrock dust or other construction materials. Both WallVIEW
trim plates are painted an unobtrusive white painted finish. The
trim plates can be painted to match any décor (see Figure 9).
Installation
Complete
Figure 9:
The Vaddio WallVIEW 50i
HideAway shown closed.
Note: The door and surrounding
trim plates are paintable to
match the décor in any room.
Important Note:
Mask or Remove the IR Sensor
prior to painting the surrounding
trim plates. Re-install IR Sensor
after paint has dried completely.
IR Sensor: Relays IR
signals from IR Remote
to the camera with the
door closed. Painting
the sensor will block the
IR from reaching the
camera. Mask or
remove the IR Sensor
prior to painting trim.
White nylon screw
(nylon nut on
backside) attaches
IR Sensor to the
surrounding trim
plate.
Figure 8:
Canon WL-V5 Remote and
Universal On/Off button
The WallVIEW 50i will respond to all
of the WL-V5 remote commands
with the On/Off button opening and
closing the WallVIEW.
On = Open
Off = Closed
Operating
the Camera
