WallVIEW 50i HideAway – Document 341-141 Rev. C
Page 5 of 14
cables to the RS-232 IN (from ControlVIEW Xtreme or control
system) and RS-232 OUT (to the next Vaddio VISCA controlled
camera product in the control chain. A closure pair (voltage
sensing) is also provided to control the opening of the WallVIEW
50i PTZ HideAway independent of the IR remote controller
provided with the system. To take advantage of this feature, an
additional two-conductor cable is a requirement (see Figure 4).
9. Using the four (4) ¼” x 2” supplied toggle screws, insert the
screws through the front of the mounting flange’s mounting
holes and secure the toggles to the screws but only turn two or
three threads. Verify that the toggles open toward the back of
the mounting flange. Carefully insert the camera module
backbox with attached cables into the drywall-mounting hole
aligning the toggle bolts and press firmly and completely into the
wall. Tighten the four mounting screws securely but do not over
tighten.
10. Connect the Cat. 5 cable from the WallVIEW 50i PTZ HideAway
POWER/VIDEO Jack to the supplied Vaddio Quick-Connect
Box. This single Cat. 5 cable is broken out to the following
connections (see Figure 5):
•
S-Video Output
•
Composite Video Output
•
Power Supply Input
Figure 4:
Cat. 5 connections and
closure pair in camera
module (under camera)
Note: The closure pair
opens the WallVIEW
camera door when the
camera is off and has
power available ONLY.
The closure pair will not
raise the camera.
RS-232
OUT
POWER
VIDEO
RS-232
IN
Closure Pair
(For limited use
only)
Camera
Mounting
Connection
Figure 5:
Vaddio Quick-Connect Box for
power and video breakout
•
Note: Rack mountable Quick-
Connect bracket is available as
an option.
Connection
