Selecting the Installation Area
Install the camera in a location that meets the following requirements.
Note
Work must conform to local building codes and should be performed by qualified personnel.
Environment:
This product is designed for indoor use only.
Structural requirements:
n
The enclosure is designed to be mounted into a wood or steel stud wall 16 in. (40.6 cm) on center, or to
a drywall surface at least 0.5 in (1.27 cm) thick.
n
If the wall studs are on greater than 16 in. centers, you will need to mount to drywall on at least two
corners.
Safety:
Ensure that no obstructions of any kind are present in the area that the camera enclosure will be set
into.
Warning
Before cutting the opening for the camera enclosure, ensure that no wiring is present in or immediately
adjacent to the area that the camera enclosure will be set into. Cutting or drilling into electrical wiring can
cause electrical shock or fire, resulting in death, injury, and damage to the building.
Warning
Before cutting the opening for the camera enclosure, ensure that no pipes are present in or immediately
adjacent to the area that the camera enclosure will be set into. Cutting or drilling into gas pipes can cause
explosion or fire, resulting in death, injury, and damage to the building. Cutting or drilling into water or
wastewater lines can result in injury and damage to the building.
Performance:
n
Choose a camera mounting location that will optimize camera performance. Consider camera viewing
angles, lighting conditions, and line-of-sight obstructions where the camera is to be mounted.
n
If the remote control will be used, ensure that nothing blocks the IR lens in the camera enclosure.
7
Installation Guide for the RoboSHOT IW Architectural PTZ Conferencing Camera
