Installing the Power Source
You can connect the camera to the IP network using a mid-span power injector, or you can connect it to a
OneLINK device. If you use a OneLINK device, it may be installed up to 328 ft (100 m) from the camera.
1. Install the power injector or OneLINK device before installing the camera enclosure.
2. Route the camera cable from the power injector or OneLINK device to the camera enclosure location.
Pre-Installation Functional Check
Before you install the camera, verify that it powers up and sends video. Referring to the basic connection
diagrams, connect the camera and verify that video is available on the connected display.
When you have verified that the camera operates properly, disconnect it and continue with the installation.
Basic Connections
Connecting the camera is simple – just connect the cable to the OneLINK device or to the Power + Data
connector of the mid-span power injector.
The diagrams below show basic connections to other components of the room system.
RoboSHOT IW OneLINK Bridge System
RoboSHOT IW OneLINK HDMI System
8
Installation Guide for the RoboSHOT IW Architectural PTZ Conferencing Camera