All equipment sold under the VACPAK-IT trademark and used for commercial purpose is warranted against
defects in materials and workmanship. The warranty runs for 1 year from time of purchase and is for the
benefit of the original purchaser only. All other warranties, Expressed or Implied, Statutory or otherwise,
including Without Limitation and any implied warranty of Merchantability or Fitness for Purposes are
excluded. The seller shall in no event be liable for direct, indirect, or consequential damages in connection
with VACPAK-IT commercial products.
This warranty is not effective if damage occurs due to accident, carelessness, improper installation, lack
of proper set-up, supervision when required, or if the equipment is installed or operated in any manner
contrary to the installation and operating instructions. Work performed by unauthorized personnel or
unauthorized service agencies voids this warranty. This warranty explicitly does not apply to, and VACPAK-
IT is not responsible for, any warranty claims made on products sold or used outside of the United States.
Cleaning
Storage
This model is intended for indoor use only at commercial food service establishments.
It is designed to provide precise temperature control of water for closed loop circulation.
To extend the life of this model, please clean every 20 uses, or 100 hours of use.
1. Fill a container with a solution of water and vinegar.
2. Turn the circulator head on and let it circulate water for 20 minutes.
3. Repeat this process with a container full of clean water to rinse.
4. To clean the filter, unplug the machine and allow it to cool down.
Open the machine housing and use a soft brush to remove particles from filter.
1. Store the model in an upright position after use to prevent water from
leaking into the top portion.
2. If liquid gets into the top part of the model, turn the power off and dry
with a clean towel before use.
MAINTENANCE
4.
ISSUE
REMEDY
No power
to the unit
• Ensure the machine is properly plugged into a grounded outlet.
• Check the power cord for tears, frays, or other damage.
Do not use machine if the power cord is damaged.
The unit is no
longer heating
• Ensure that the water level is between the MIN and MAX fill lines
marked on the head. If not, allow the unit to cool and add water
until the level reaches between these 2 marks.
