This appliance is designed for wrapping fruits, vegetables, fish, meat, cold food, etc.
1. To load film onto film rod, place film roll onto film roll bearing blocks, tighten the wing nuts
and put the plastic caps onto threaded ends.
2. Flip cover plate upward.
3. Route the film between cover plate and film retainer rod. (See Film Loading Diagram)
4. Insert the power cord plug into a properly grounded outlet.
5. Turn the main switch on and the red indicator lamp will light up.
6. Flip cover plate downward to original position.
7. Turn the thermostat to set the desired temperature.
8. Allow 5-10 minutes for the unit to pre-heat.
9. Place food onto the cover plate.
10. Draw out the film and cover the package, tucking several inches of film underneath. Pull the
package toward you to completely enclose it in film.
11. Use the Cut Off Bar to cut film.
12. Place wrapped package onto hot plate for 3-5 seconds to seal.
REPLACEMENTS PARTS
Operating instructions
film loading diagram
Item Number
Description
PWM18212
Fuse - 1A, 250V
PWM1824
Cut Off Rod
PWM5901
Teflon® Cover
PWM6101
Hot Plate Assembly
CUT OFF ROD
COVER PLATE
PLASTIC CAPS
WING NUTS
FILM ROLL
BEARING BLOCK
FILM ROLL
FILM
CONTROL BOX
FILM RETAINER
ROD
HOT PLATE
3
