Vacon CXS Series, Руководство по установке

Страница: 8 / 17

Vacon Page 7 (15)
I/O-expander board installation (Vacon CXS-range)
Vacon Plc Tel: +358-201 2121 Fax: +358-201 212 205
Service: +358-40-8371 150 E-mail: vacon@vacon.com
http://www.vacon.com
Connect the shielded data cable for I/
O-repeater board (2) to the control
board terminal X14.
7
5
Set the protection foil (6) above the I/O-repeater board as shown in the picture. Make sure
that the protection foil is correctly located, push the "arms" of the protection foil under the
control panel cover. Fasten the I/O-repeater board and protection foil to the stand sleeve (7)
with the screw.
X14
Install the control panel cover with 4
screws.
6
8
Connect the power cable (4) to the I/O-repeater terminal X1 and communication cable (9) to
the I/O-repeater terminal X3. Uncover carefully the shield of the communication cable (max.
1,5 cm), tighten up to the metal clamp (of the cable) and earth the cable to the frequency
converter ground as shown in the picture.
Table 3-2. I/O-expander board installation (continues ...).
4
9
6
7