Va co n
Page 7 (1 5 )
I/ O - ex p a nd er b oa r d insta lla tion (Va con CX S- r a ng e)
Vacon Plc
Tel:
+3 5 8 -2 0 1 2 1 2 1
Fax:
+3 5 8 -2 0 1 2 1 2 2 0 5
Service:
+3 5 8 -4 0 -8 3 7 1 1 5 0
E-mail:
[email protected]
http:/ / w w w.vacon.com
Connect the shielded data cable for I/
O -repeater board (2 ) to the control
board terminal X1 4 .
7
5
Set the protection foil (6 ) above the I/ O -repeater board as show n in the picture. M ake sure
that the protection foil is correctly located, push the "arms" of the protection foil under the
control panel cover. Fasten the I/ O -repeater board and protection foil to the stand sleeve (7 )
w ith the screw.
X14
Install the control panel cover w ith 4
screws.
6
8
Connect the pow er cable (4 ) to the I/ O -repeater terminal X1 and communication cable (9 ) to
the I/ O -repeater terminal X3 . Uncover carefully the shield of the communication cable (max.
1 ,5 cm), tighten up to the metal clamp (of the cable) and earth the cable to the frequency
converter ground as show n in the picture.
Table 3 -2 .
I/ O -expander board installation (continues ...).
4
9
6
7
