Vacon CX, Руководство по установке

Страница: 14 / 17

Va co n Page 1 3 (1 5 )
I/ O - ex p a nd er b oa r d insta lla tion (Va con CX S- r a ng e)
Vacon Plc Tel: +3 5 8 -2 0 1 2 1 2 1 Fax: +3 5 8 -2 0 1 2 1 2 2 0 5
Service: +3 5 8 -4 0 -8 3 7 1 1 5 0 E-mail: vacon@vacon.com
http:/ / w w w.vacon.com
Terminal Signal Description
201 + 1 0 V
ref
Reference output Voltage for a potentiometer, etc.
202 U
i n
+ Analogue input, voltage N ot in use
range 0 — 1 0 V DC
203 G N D I/ O ground G round for reference and controls
204 U
i n
+ Analogue input, voltage N ot in use
205 U
i n
- range 0 — 1 0 V DC
206 + 2 4 V C ontrol voltage output Voltage for sw itches, etc. max. 5 0 mA
207 G N D I/ O ground G round for reference and controls
208 CM C C ommon for DIC 1 -DIC 5 C onnect to G N D or + 2 4 V
209 DIC 1 External fault C ontact open = no fault
(closing contact) C ontact closed = fault
210 DIC 2 Run disable C ont. open = start of motor enabled
C ont. closed= start of motor disabled
211 DIC 3 Acceler. / Decel. time C ontact open = time 1 selected
selection C ontact closed = time 2 selected
212 DIC 4 Jogging speed selection C ontact open = no action
C ontact closed = jogging speed
213 DIC 5 Fault reset C ontact open = no action
C ontact closed = fault reset
214 DI6 A + Pulse input A
215 DI6 A- (differential input)
216 DI7 B+ Pulse input B 9 0 degrees phase shift compared
217 DI7 B- (differential input) to pulse input A
218 DO 1 Encoder direction output
219 DO 2 Encoder divider 1 / 6 4 output
220 U
o ut
+ Analogue output Programmable
0 — 1 0 V DC / R
L
≥ 1 k Ω (M otor voltage as default value)
221 TI + Thermistor input
222 TI-
223 RO 3/ 1 Relay output 3 READY
224 RO 3/ 2
225 RO 4/ 1 Relay output 4 RUN
226 RO 4/ 2
227 RO 5/ 1 Relay output 5 FAULT
228 RO 5/ 2
4 . 3 Va con CX1 0 2 O PT
Figure 4 -3 Control connections of Vacon CX1 0 2 O PT.
Signal from
motor thermistors * )
* ) N O TE! Thermistor input (terminals 2 2 1 and 2 2 2 ) must be shorted if not used.
Enco -
der