Page 6 (1 5 )
Va co n
I/ O - ex p a nd er b oa r d insta lla tion (Va con CX S- r a ng e)
Vacon Plc
Tel:
+3 5 8 -2 0 1 2 1 2 1
Fax:
+3 5 8 -2 0 1 2 1 2 2 0 5
Service:
+3 5 8 -4 0 -8 3 7 1 1 5 0
E-mail:
[email protected]
http:/ / w w w.vacon.com
Table 3 -2 .
I/ O -expander board installation (continues ...).
1
2
4
Remove the control panel, control panel base (4 screw s) and the jumper X4 from the
control board.
3
3 .2
IN STA LLATIO N
I/ O -repeater board (1 ) should be installed above the control board inside the frequency con-
verter. The I/ O -expander board (1 0 ) and I/ O -interface board (1 1 ) should be installed in the
option box. Follow the instructions below (see Table 3 -2 ).
C heck that the jumper for I/ O -repeater board
(1) is in the right position in terminal X5 (3).
The position of the jumper must be chosen according to the I/ O -expander board
(11)
:
- If I/ O -expander board C X1 0 1 O PT or 1 0 3 O PT
is in use, jumper must be in position A.
- If I/ O -expander board CX1 0 0 O PT or 1 0 2 O PT
is in use, jumper must be in position B.
- If one of the follow ing fielbus boards is in use:
CX2 0 0 O PT, CX2 0 1 O PT, CX2 0 2 O PT or
C X2 0 3 O PT, jumper must be in position C .
(Positon D is not in use).
X5
X4
M ake sure that the cable of the control panel
cover is connected to the control board X1 ter-
minal. C onnect the 4 -pole pow er cable
(4) to
the control board X5 terminal (The pow er cable
can also be connected to the X6 -terminal, if the
pow er cable from the pow er board is connected
to the X5 -terminal.)
Set the protection foil
(5) above the control
board as show n in the picture. M ake sure that
the protection foil is correctly located, the hole
in the foil w ill must be located above the stand
sleeve.
X5
Remove the fixing screw from the control board
and replace it w ith the stand sleeve
(7).
5
7
