Vacmaster VWM1218R, Руководство оператора

Страница: 13 / 64

12
Clockwise, do not over tighten. (fig. 3 & 4)
Removing and Cleaning Cartridge Filter
1. Unlock and remove the filter retainer by turning retainer handle counter clockwise.
2. Carefully hold and pull the cartridge filter up for removal. (fig. 5)
3. Clean the cartridge filter by gently tapping or brushing dirt off. Cleaning should not be done indoors in
living areas. For optimal performance a new filter is recommended.
4. Install cleaned or new filter into place as instructed above in steps 2 and 3 of Installing Cartridge Filter.
5. Wet filters should be removed and allowed to air dry for 24 hours before installing onto the filter cage.
Installing Foam Sleeve Filter
1. Verify that the power cord is disconnected from the outlet
2. Remove power head and place in upside down position. Follow instructions to remove cloth filter.
3. Carefully slide foam sleeve filter down over the filter cage making sure the whole cage is covered.
(fig.1 & 2)
4. Replace the power head on to the container.
Cleaning Foam Sleeve Filter
1. With the removed power head in the upside down position, carefully remove foam sleeve filter. (fig. 3)
2. Use a mild soap and water solution to wash foam sleeve filter and rinse with clean water. (fig. 4)
3. Allow filter to air dry before installing and using again.
Resetting The Remote Control
1. Set the power switch to remote control position “ ”. (fig. 1)
2. Press the RESET button on the side of the power head with a pen tip until the indicator lights up. (fig. 2)
3. Within the 15 seconds, press and hold the “O” or “I” button on the remote control. If you didn’t press and
hold the “O” or “I” button within the 15 seconds, it will cancel this resetting. (fig. 3)
4
. When the light blinks 3 times, this means the remote control is programmed.
O = OFF I = ON
INSTALLING & CLEANING FOAM SLEEVE FILTER
RESETTING THE REMOTE CONTROL
GB