Vacmaster VWM1218R, Руководство оператора

Страница: 9 / 64

8
5. Your vacuum comes ready for dry vacuum cleaning. If the cartridge filter is not installed refer to page
11 for filter installation.
（
fig. 12 & 13
）
6. Optional, for improved dust filtering, fit dust bag flange onto the inlet stub, taking care not to damage
the bag. (fig.14)
7. For wet vacuum cleaning, install the supplied foam filter. (fig. 15) See page 12 for filter installation.
8. Place the power head back on the container, and secure into place using the 2 side latches. (fig. 16 & 17)
9. Insert the locking end of the hose into the port of the container and lock in to place. (fig. 18)
10. Choose the desired accessories and push onto the suction tube. (fig. 19)
DISMOUNTING THE VACUUM FROM THE RACK
1. Disconnect the power cord form the electrical outlet. (fig. 1)
2. Press the release lever with your left hand. (fig. 2)
3. Lift the vacuum up and out of the rack by the handle with your right hand. (fig. 3)
DRY VACUUMING
WARNING:
BE SURE TO READ, UNDERSTAND, AND APPLY INFORMATION, ENTITLED
‘SAFETY INSTRUCTIONS & WARNINGS’. DO NOT VACUUM IN AREAS WITH FLAMMABLE GASES,
VAPORS, OR EXPLOSIVE DUSTS IN THE AIR. FLAMMABLE GASES OR VAPORS INCLUDE BUT
ARE NOT LIMITED TO; LIGHTER FLUID, SOLVENT TYPE CLEANERS, OIL-BASE PAINTS, GASOLINE,
ALCOHOL OR AEROSOL SPRAYS. EXPLOSIVE DUSTS INCLUDE BUT ARE NOT LIMITED TO;
COAL, MAGNESIUM, GRAIN OR GUN POWDER. TO REDUCE THE RISK OF HEALTH HAZARDS
FROM VAPORS OR DUST, DO NOT VACUUM TOXIC MATERIALS.
1. Verify that the power cord is disconnected from the outlet. (fig. 1)
DRY-VACUUM OPERATION
GB