Vacmaster VWM1218R, Руководство оператора

Страница: 10 / 64

9
2. In order to prepare your vacuum for dry vacuuming, verify that the cartridge filter is securely mounted.
Make sure the filter is pushed in until it stops against the power head. (fig. 2) (Your Wet/Dry Vac comes
with the cartridge filter pre-installed, if not see page 11 for installation instructions.)
3. Place filter retainer on top of cartridge filter and tighten down by turning the retainer handle clockwise.
(fig. 3)
4. Optional, for improved dust filtering, fit dust bag flange onto the inlet stub, taking care not to damage
the bag. (fig.4 )
5. Place the power head back on the container, aligning the top section with the latches, and snap into
place. (fig. 5)
OPERATING INSTRUCTIONS: DRY VACUUMING
6. Insert the locking end of the hose into the vacuum port on the power head and lock in place. Push the
required attachment onto the free end of the hose or extension. (fig. 6)
7. Plug in the power cord into the outlet and hang the vacuum onto the rack or use off the rack . (fig. 7)
8. Turn the motor on by flipping the switch to the ‘I’ ON position. (fig. 8) For remote control use, set the
power switch to remote control position “ ” and turn the vacuum on by pressing the ‘I’ ON
button on the remote control handle for at least one second . (fig. 9 & 10)
9. Once you have completed vacuuming, flip the switch to the ‘O’ OFF position or press the ‘O’ OFF button
on the remote control at least one second .
O = OFF I = ON = Remote Control
DO NOT USE THE CARTRIDGE FILTER FOR LIQUID VACUUMING.
* Fig.10a only for 42mm; Fig 10b only for 35mm
LIQUID VACUUMING
WARNING:
BE SURE TO READ, UNDERSTAND, AND APPLY INFORMATION, ENTITLED
‘SAFETY INSTRUCTIONS & WARNINGS’. DO NOT VACUUM IN AREAS WITH FLAMMABLE GASES,
VAPORS, OR EXPLOSIVE DUSTS IN THE AIR. FLAMMABLE GASES OR VAPORS INCLUDE BUT
ARE NOT LIMITED TO; LIGHTER FLUID, SOLVENT TYPE CLEANERS, OIL-BASE PAINTS, GASOLINE,
ALCOHOL OR AEROSOL SPRAYS. EXPLOSIVE DUSTS INCLUDE BUT ARE NOT LIMITED TO;
COAL, MAGNESIUM, GRAIN OR GUN POWDER. TO REDUCE THE RISK OF HEALTH HAZARDS
FROM VAPORS OR DUST, DO NOT VACUUM TOXIC MATERIALS.
WARNING:
DO NOT PLUG IN POWER CORD TO POWER OUTLET, MAKE SURE PLUG IS
DISCONNECTED BEFORE ASSEMBLING THE WET/DRY VAC
IMPORTANT!
When vacuuming large quantities of liquids, we recommend that you remove the vacuum
from the mounting rack and put it on the floor. The vacuum can be heavy when full of liquids and may be
difficult to remove from the rack.
1. Verify that the power cord is disconnected from the outlet. Verify that the container is clean and free of
dust and dirt. (fig. 1)
LIQUID VACUUM OPERATION
GB