Vacmaster CARDIO54 AM1202R, Руководство пользователя

Страница: 8 / 16

8
GB
change to desired speed, press the , , or button as necessary (Fig. 2).
3) The air mover can also be started by pressing the desired speed setting on the remote control
initially.
4) Press the button again, to return the air mover into standby mode. The indicator light will
illuminate red.
5) To completely switch off the air mover, press the on/off switch to "0" OFF position.
3. Pairing A Remote Control with Your Air Mover
If a new or replacement remote control is used, or the current remote control is not able to operate
the air mover, reset the remote control by following the instructions:
1) Ensure the air mover is turned off by pressing the on/off switch into the “0” OFF Position.
2) Switch the speed control knob to
position.
3) Restart the air mover by pressing the on/off switch to "I" ON position.
4) Within first 5 seconds, immediately press the
button on the remote control. The indicator
light will flash red until the button is released.
The indicator light on air mover shows the status as below:
Symbols Indicator Light Status
Green, Continuous Operational
Red, Continuous Standby
Red, Flashing Pairing/Receiving instructions
4. Affixing Remote Control Strap
The remote control can be conveniently stored in the holder located on the strap.
1) Place the remote control unit into the holder within the strap. Remote control should sit
securely.
2) The strap can be used to attach onto a handle located for example on a treadmill or exercise
bike. To secure the strap, loop the strap around the handle and secure the locking tap into the
available outlet (Fig. 3).
5. Air Mover Positioning
1) Place the air mover in the desired position on a flat and stable surface. Ensure there is at least
a foot of clearance on each side of the air mover. Avoid placing the air mover where loose
fabric, sheets, or other objects can get pulled onto the intake grills.
2) Direct the air mover at the designated target area, using one of the operational positions (Fig. 4).
CAUTION:
When using an extension cord, be sure to use an extension cord that
has the capacity to handle the current the product will draw. An undersized cord will cause a
drop in voltage, resulting in overheating and loss of power. Before using any extension cord,
inspect it for loose or exposed wires and cut or worn insulation.
WARNING:
Do not stack air movers vertically during operation. To reduce risk of
overheating or overload, ensure area around intake grills are clear to allow for unobstructed
air flow.