Installation instructions
CombiCooler/Cooler/WineCooler/Freezer
V6000 Supreme, integrated
1091916-R01
07/05/2020
1091916-R01
7
View from back (left) and side
view (right).
= Electrical connection
= Water connection (depending
on model)
A 16 A schuko socket or 10 A type 12/13 socket with earth conductor protected by an easily accessible all-pole switch must be
provided for the electrical connection. A tap with a ¾ inch external (male) thread must be provided for the water connection (in appli-
ances with an ice-maker) and must also be easily accessible after the appliance has been installed. Only the hose included in the
scope of delivery should be used to connect the appliance to the tap. The appliance must be connected to the drinking water supply,
taking into account the current regulations of the country in which the appliance is being installed, and for the CombiCooler V6000 Su-
preme (51096) and – depending on the water quality – also for the Freezer V6000 Supreme (51099) the water filter cartridge supplied
be installed, as explained in the instructions provided. The water hose can be shaped by heating (max. temperature 120 °C / 248 °F)
without the risk of causing throttle points (max. bending radius 40 mm - 1 5/8 inch). The hose can be restored to its original shape by
reheating it.
Mains cable with plug, length 200 cm,
Water connection pipe, length: 250 cm. Procedure:
▸
Unwind the power cord and plug it directly into the wall socket.
▸
Make sure the appliance is on stand-by and that the illumination is off; if not, hold the
button depressed for 3 seconds and then confirm.
–
The appliance is switched off.
▸
Connect the water hose at the back of the refrigerator.
▸
Connect the water hose to the tap using the seals included in the scope of delivery.
Levelling the appliance
Level the appliance by adjusting the feet and the back rollers underneath. Procedure:
2
3
2
3
1
▸
Remove the cover grille
1
(held in place by magnetic strips) and then adjust the height of
the feet
2
using a 17 mm (3/4 inch) open-end wrench.
▸
Adjust the height of the back wheels by turning the front bolts
3
clockwise or anti-clock-
wise, where required.
▸
Replace the base / cover grille.
–
The appliance now stands even/level.
