![background image](http://html1.mh-extra.com/html/v-zug/combair-v4000-45/combair-v4000-45_operating-instructions-manual_3278560053.webp)
8 Care and maintenance
▸ Fit the seal starting in one of the corners at the
top.
▸ Insert the clip so that it hooks into the outer
slot.
▸ Once the seal is fitted at the top, insert the bot-
tom two clips.
▸ Lightly press the seal into the groove all
around, i.e. along the top, bottom, left and
right.
1.
2.
3.
4.
X
Checking the seal is seated properly
All four clips must be hooked in.
▸ If not, remove the seal and put the corner hooks in again.
▸ Lightly press the seal into the groove all around, i.e. along the top, bottom, left and
right.
8.9
Replacing the halogen light bulb
WARNING: Risk of electric shock!
Disconnect the appliance from the mains power supply before replacing the halo-
gen light bulb.
Risk of burns from hot surfaces!
Allow the halogen light bulb and the appliance to cool down before replacing the
halogen light bulb.
Do not touch the halogen light bulb with bare hands. Instead, use a fine, dry,
grease-free cloth.
Overhead illumination
▸ Carefully turn the glass light cover
1
clockwise
and remove.
▸ Take out the faulty halogen light bulb.
▸ Carefully fit the new halogen light bulb.
▸ Turn the glass light cover
1
anti-clockwise to
tighten.
▸ Reconnect the power supply.
1
Lateral illumination
▸ Remove the left shelf guide.
▸ Place the screw driver along the middle of the
edge of the glass and carefully remove the
glass light cover
2
from its fixture.
▸ Take out the faulty halogen light bulb.
▸ Carefully fit the new halogen light bulb.
▸ Press the glass light cover
2
back into its fix-
ture.
▸ Replace the shelf guides.
▸ Reconnect the power supply.
2
53