![background image](http://html1.mh-extra.com/html/v-zug/combair-v2000/combair-v2000_operating-instructions-manual_3158911045.webp)
8 Care and maintenance
Removing the door seal
▸ In each of the four corners, turn the seal out-
wards by about 30° and carefully pull the clip
out of the slot.
▸ When all four clips have been released, re-
move the seal.
▸ Clean the groove in the appliance with a damp
cloth.
1.
2.
3.
4.
X
Fitting the door seal
The joint and vent hole
X
must be at the left in the middle.
▸ Fit the seal starting in one of the corners at the
top.
▸ Insert the clip from the outside to the inside at
a 30° angle into the slot. Once the seal is fitted
at the top, insert the bottom two clips.
▸ Press the door seal into the groove all around,
i.e. at the top, bottom, left and right.
1.
2.
3.
4.
X
8.7
Replacing the halogen light bulb
WARNING: Risk of electric shock!
Disconnect the appliance from the mains power supply before replacing the halo-
gen light bulb.
Risk of burns from hot surfaces!
Allow the halogen light bulb and the appliance to cool down before replacing the
halogen light bulb.
Do not touch the halogen light bulb with bare hands. Instead, use a fine, dry,
grease-free cloth.
Overhead illumination
▸ Carefully turn the glass light cover
1
clockwise
and remove.
▸ Take out the faulty halogen light bulb.
▸ Carefully plug the new halogen light bulb into
the socket – halogen type G9 / 25 W / 230 V.
▸ Turn the glass light cover
1
anti-clockwise to
tighten.
▸ Reconnect the power supply.
1
45