2
Using for the first time
After changing the location of an appliance that has a heat pump, it must be left to
stand in the normal operating position for around 2 hours before it can be operated
again.
The appliance must be installed and connected to the electricity supply by a quali-
fied fitter/electrician in accordance with the separate installation instructions.
2.1
Before using for the first time
Before operating the newly installed appliance for the first time, the following steps
should be taken:
▸ Switch on the power and turn on the water tap.
▸ Set the water hardness
in the user settings (see page 41).
▸ Fill the salt reservoir with approx. 1.0 l water and 1 kg regeneration salt (see page
46).
▸ Wipe away any excess salt around the edge of the salt reservoir.
▸ Fill the rinse agent reservoir with rinse agent (see page 47).
▸ Select (see page 28) and add (see page 29) the detergent.
▸ Run the «Intensive»
programme without dishes to protect the appliance from cor-
rosion from any excess salt and to remove traces of grease left behind from the man-
ufacturing process.
The
refill indicator can flash during the first few wash cycles.
goes out when
the salt concentration in the reservoir is evenly distributed.
2.2
Setting the door weight
Testing the 30° opening angle
▸ Check whether the appliance door stays
open at an opening angle of approx.
30°.
If the appliance door swings open in an un-
controlled fashion:
▸ Open the appliance door approx. 30°
and hold it in this position.
▸ Tighten the screws until the appliance
door stays open in this position on its
own.
9
Содержание AdoraDish V6000
Страница 4: ...4 15 Service Support 59 ...