2
Using for the first time
The appliance must be installed and connected to the electricity supply by a quali-
fied fitter/electrician in accordance with the separate installation instructions.
Before operating the newly installed appliance for the first time, the following steps
should be taken:
2.1
Before using for the first time
▸ Switch on the power and turn on the water tap.
▸ Set (see page 23) the water hardness.
▸ Fill the salt reservoir with approximately 1.0 l water and 1 kg regeneration salt. Wipe
away any excess salt on the edge of the salt reservoir.
▸ Fill the rinse agent reservoir with rinse agent.
▸ Run the
programme without dishes to protect the appliance from corrosion from
any excess salt and to remove traces of grease left behind from the manufacturing
process.
The refill indicator can flash during the first few wash cycles. goes out when the salt
concentration in the reservoir is evenly distributed.
Setting the door weight
Set the door weight, if required.
7
