V-ZUG 51027, Руководство по эксплуатации

Страница: 38 / 112

34
No scouring cleaners or scratching cloths
are to be used.
Clean the door seals with a
soft brush. If the appliance has not been
used for some time, turn off by using the
main switch. Empty the appliance, defrost
it, clean, and then leave the cold room as
well as the freezer compartment open.
– For cleaning the control element please
use only a humid flannel.
– Be careful that as little cleaning water as
possible goes though the drainage
channel into the collection dish.
– Before being put back in use, the appli-
ance and the seals of the cold room and
the freezer must all be completely dry.
Informations for energy-saving use
■
As far as possible, use the cooling unit in
its as-delivered state. The arrangement
of drawers, shelves and trays ensures the
best possible temperature distribution.
■
Do not install the unit near radiators,
radiator pipes or smoke extractors and
protect it as far as possible from direct
sunlight
■
Make sure the unit doors are kept open
for as short a time as possible. The
quicker the doors are closed again, the
less cold is lost.
■
Make sure that the doors are closed fully
and correctly. The door seal must be
flush against the frame of the fridge.
■
Leave warm or even hot items to cool
down outside the unit.
■
The storage of moisture-releasing food-
stuffs leads to increased build-up of ice
on the rear of the fridge and a reduction
in cooling power.
Tips
The following points should be noted
when using the new appliance:
■
A appliance which has just been put into
use needs approx. 15 hours (with prod-
ucts) until it has reached its normal oper-
ating temperatures.
■
If the doors are open for longer than
2 minutes then the lamp starts to flash.
Make sure after closing that the doors
are fully sealed. The self-closing hinges
assist this.
■
The cooling time for beverages and other
products can take up to 6 hours from
room temperature down to the cold
room temperature. The warmer they are
when put in, the longer this time will be.
■
Re-setting the temperature control has
no effect on the cooling rate, only on
the temperature reached.
■
Condensation can form on the glass
shelves if products are stored which emit
water vapour.
■
The electronic control defrosts the cold
room only about once per day. A cat ice
may be visible oftentimes at the back
board of the cold room – this is though
normal.
■
Be careful that products do not come
into contact with the rear wall of the
cold room so that they do not freeze to
it and that, during defrosting, water
does not get diverted into the cold
room.