Installation instructions
Heat pump dryer
Multi-family building
J173.113-0
6.4.11 ITH
6
When the appliance is connected to the power supply for the first time, it is possible to select a function test. The purpose of the function
test is to check the installation and it lasts about 3 minutes. For the function test, it is not necessary for the appliance to have been
standing in the normal operating position for approx. 2 hours, as the heat pump is not started. The function test can therefore be selected
immediately after installation.
Starting the function test
➤
Connect the appliance.
– In the display
appears and the indicator lights for the buttons
and
flash.
➤
Press the
button.
– The function test starts and
appears in the display.
Completing the function test
– On completion of the function test
appears in the display.
– The display goes out automatically after 30 minutes or after the following actions:
➤
Open the appliance
or
➤
press the
button.
Interrupting the function test:
The function test can be interrupted in 2 ways:
1. Open the appliance door.
– In the display
appears.
– After closing the appliance door
appears in the display.
Or
2. Press the
button.
– In the display
appears.
Aborting the function test:
– In the display
appears.
➤
Press the
button.
– In the display
appears.
4. Using for the first time
The function test cannot be aborted by power outage.
Once the function test has been run, it can no longer be selected and the appliance enters the normal selection mode.
The appliance is only ready to operate after the required waiting time of approx. 2 hours in the normal operating
position
. Failure to observe this can result in damage to the appliance.
Function test pause
next
abort
Function test
0h03
Function test
complete
Function test pause
Close appliance door
Function test pause
next
abort
Function test pause
next
abort
Function test pause
next
abort
Function test
complete
