Version 06.04.2017
CI-VL2-SY2-N
P
a
g
e
19
3.
Interface operation
3.1.
By Voice button
To switch the Video sources the vehicle’s
Voice button
can be used
(pay attention to dip4 in the CAN box, refer chapter “Dip-switch
settings of the CAN-box”).
Each press will switch to the next enabled input. If all inputs are
enabled the order is:
Factory video
RGB-in
video IN1
video IN2
factory video
…
Disabled inputs will be skipped. While switching from video in-1 to video in-2 the Audio-
source will be switched too, assuming the sources have also been connected to the audio
cable
Switchover by vehicle buttons isn’t possible in all vehicles. In some vehicles the external
keypad has to be used.
Note:
The white wire of the 6pin cable can be used with a +5-12V pulse to switch the video-
sources alternatively.
3.2.
By keypad
Alternatively or additionally to the factory infotainment button, the interface’s external
keypad can be used to switch the enabled inputs.
4.
Specifications
BATT/ACC range
7V - 25V
Stand-by power drain
<10mA
Power
0.7A @12V
Video input
0.7V - 1V
Video input formats
PAL/NTSC
RGB-video amplitude
0.7V with 75 Ohm impedance
Temperature range
-40°C to +85°C
Dimensions video-box
155 x 22 x 90 mm (W x H x D)
Dimensions CAN-box
73 x 22 x 30 mm (W x H x D)
