Version 06.04.2017
CI-VL2-SY2-N
P
a
g
e
11
2.5.
Connection to the vehicle’s monitor
Remove the vehicle’s monitor and turn off the 12 OEM screws of the monitor`s frame
for folding up the monitor panel from it`s housing. Do not loosen the 3 bigger screws
on the monitor’s rear side!
Pull out the brown colored 4pin touch ribbon cable from the original PCB. The
disconnecting is only necessary for the easy installation procedure! After the
installation of the daughter PCB is done, it has to be reconnected at the same place!
Remove the 60pin ribbon cable from the original PCB by unclipping the Ribbon cable
base and connect it to the daughter PCB’s 60pin ribbon cable base “OUT PNL”. Make
sure that the connector pins of each pin connector are faced to the platinum before
clipping them.
Connect the daughter PCB’s 60pin ribbon cable to the free 60pin ribbon cable base at
the original PCB (take care again for a platinum faced installation of the connector
pins!).
Turn off the 2 screws of the original PCB and fix the daughter PCB onto it, by using
the enclosed screws and washers (different mounting points are possible –refer to
chapter “Place of installation for the daughter PCB”). The long holes of the daughter
PCB will permit a straight mounting and the perfect connection of the ribbon cables
Connect the beige colored male 20pin connector (
Monitor Side
) of the 20pin cable to
the female 20pin connector of the daughter PCB and connect the second beige
colored male 20pin connector (
Box Side
) opposite the cable to the female 20pin
connector of the video interface. Take care for installing the cable in the right
direction as both connectors are identical. (Pay attention to the wire`s caption
“
MONITOR SIDE” and “BOX SIDE
”)
