7
Assembly
Attach the Handlebar (6) to the Saddle Stem (5) using 2 x M8 x 45mm Carriage Bolts
(22), 2 x M8 Flat Washers (8), 2 x M8 Spring Washers (17) and 2 x M8 Dome Nuts (18).
Connect the Hand Pulse Sensor (35) from the Handlebar(6) with the Lower Hand Pulse
Wire (19) from the Saddle Post (2). Feed the excess wire back into the hole of the Saddle
Post (2).
8
Remove 4 x M5 x 12mm Screws (59) from the back of the Exercise Monitor (58).
Connect the Upper Sensor Wire (40) and the Upper Hand Pulse Wire (41) to the
Exercise Monitor (58). Matching like for like and feeding any excess wire back
into the Handlebar Upright (7). Carefully slide the Exercise Monitor (58) onto the
Exercise Monitor Bracket and secure using 4 x M5 x 12mm Screws (59) that were
removed.
FULLY TIGHTEN all Bolts, Nuts
and Fittings now, ensuring that
your product in located on a
clear flat surface before doing so.
Your product will now be ready
to use.
Note
Page
1
9
