Assembly
2
a). Feed the Tension Control Wire (49) up through the Handlebar Upright (7) and out
through the hole at the front, as shown below. Place the end of the Tension Control
Knob (54) into the spring hook of the Tension Control Cable (49).
b). Pull the Tension Control Cable upwards against the spring pressure and push it into
the gap on the metal bracket of the Lower Tension Cable as shown.
c). Complete the fitting as shown and if necessary, close the open section of the metal
bracket slightly with a pair of pliers as this will help to retain the cables.
d). Connect the Upper Hand Pulse Wire (41) to the Middle Hand Pulse Wire (43).
Connect the Upper Sensor Wire (40) to the Lower Sensor Wire (50).
Carefully lower the Handlebar Upright (7) onto the Main Frame (1), then loosely fit
4 x M8 x 20mm Allen Bolts (55), 4 x M8 Spring Washers (17) and 4 x M8 Curved
Washers (16). Make sure the Handlebar Support is aligned correctly and tighten
all fittings, taking care not to trap any wires.
A
Resistance
cable
Lower cable
Metal Bracket
D
Resistance
cable
Lower cable
B
Resistance
cable
Lower cable
C
Do NOT tighten the Handlebar
Upright at this stage.
The Tension Control Knob (54)
must be set at position "8".
Note
Page
1
5
