UTL GAMMA+, Руководство пользователя

Страница: 4 / 26

2. INSTALLATION
2.1 Receipt of System
When the PCU is received, please carry out visual check for any damage during
transport.
2.2 Positioning and Installation
We are suggesting the distances require to be Solar PCU:
● Minimum distance from the rear wall = 500 mm
● Minimum distance from the top = 500 mm
● Minimum distance from the front wall = 500 mm
If System is installed, then there will be hazardous AC & DC
Voltages on exposed terminals and printed circuit boards. This
condition prevails even when all the switches are OFF.
Please immediately contact Service person, Dealer or Transport
agency for following conditions occur:-
- Any damage observed, either external or internal.
- Any accessory is missing or damaged.
Avoid installing the PCU in location under direct sunlight, running water, or
excessive humidity. Routine preventive check shall be done..
Store the Solar PCU in its original Packing. Ensure the arrow on the box is
pointing vertically upward direction. Store it in dry location. Storage temperature
must be between-10 to 70°C Suitable handling equipment shall be used for
handling of PCU. The route / passage up to the installation site and the actual
foundation location must be capable of supporting the weight of the Solar PCU
and its accessories.
The system must be installed in a dry & clean room. To have proper ventilation,
the user must ensure enough air exchange in the room.
Never install the equipment near liquids or in an excessively damp environment.
Never block the ventilation.
2.3 Electrical Connection
● Ensure proper earthing of the equipment.
● Keep the Battery, Panel,Grid Input & Output disconnect during installation.
● Connect Grid Input, SPV array & Battery supply to PCU.
● Ensure the correctness of the battery & Solar Panel Array supply polarity.
● Connect load cables.
● After complete installation to power up system, Switch ON the System through
reset system, Switch ON SPV, after 30 sec. Solar Charging will be started.
● For this system add External Ckt. Breaker for solar.
Page: 2