UTIFORM Delta-Mini, Инструкция по эксплуатации

Страница: 7 / 62

Mini Pump 6
4 General safety guidelines
In order to make working with the Mini easier and safer we have listed here the most
important safety regulation which should be followed to avoid any danger when working with
the machine.
INSTRUCTIONS FOR USE
1.- The MINI is designed to mix, convey and spray mineral building materials. The
machine should only be used for the tasks for which it has been designed and the manufacturer’s
User Manual should be followed at all times.
2.- The machine should only be used by experienced personnel (machinery operators)
who have been previously instructed in the operating procedures and maintenance. They should
be familiar with its workings and have read the User Manual thoroughly.
3.- The machine should be positioned firmly on the site and secured so that there are no
unwanted movements.
4.- Machines that run on electricity need to be connected to a suitable feeder socket (one
that has a protector switch in the case of defective electrical currents).
5.- The machine must be installed at a safe distance from high scaffolding and should be
protected against any possible damage from falling objects.
6.- The conveying pipes must be fixed in such a way that any strain is absorbed by
adequate filtration points (hooks for pipes). This is especially important for pipes in a raised
position.
7.- The conveying pipes must also be positioned in such a way that no damage will
occur. If they cannot be laid completely straight and must be laid with a curve, then the radius of
the curve should be no less than six times the exterior diameter of the pipe.
8.- Use only original UTIFORM high pressure pipes for materials. These come with
built in couplings.
9.- Before switching on the machine you should check that nobody will be put in danger
by doing so.
10.- When the machine in used you must check that the conveying pipe has sufficient
prelubrication, that is, that the material used can be easily pumped and that there are no points
left unsealed at the joints of the pipe.
11.- Both in the case of activation or failure of the security devices, the machine must
be stopped until the problem has been eliminated.
12.- Before opening the conveying pipe system or any other component of the
conveying system that is under pressure, you must first check that there is no pressure in the
system.
13.- Blockages in the pipes must be eliminated following the instructions in this User
Manual. The person in charge of carrying out this operation must position himself where he will
not be reached by spraying material. Nobody else should be in the surrounding area.