UTIFORM Delta-Mini, Инструкция по эксплуатации

Страница: 22 / 62

Mini Pump 21
- Once the air diffuser has been removed from the spraying lance, the rubber ball may
be removed. Clean the air diffuser using the nozzle cleaning tool and running water.
Clean the spraying lance with water. Make sure that the material nozzle housing is
completely clean and that the nozzle is not pressurised by the pressure of the material
in the spraying lance.
- During longer pauses in work, and as a minimum whenever work has been completed,
water must be removed from the regulator, particularly when there is danger of frost
forming (cold areas); this can be done by opening both release valves. Air must also
be injected into the water valves; connect the compressor to the machine water inlet,
disconnect the water hose from the mixing tube and with the release valves open,
inject air using the electrovalve release button. The compressor is activated using the
main switch.
WARNING! :
By removing water in both summer and winter you will have no
unpleasant surprises due to frost!
- Particularly when working with smooth plaster, clean the pump outlet at least once a
day; otherwise material may be deposited in the pump outlet that can cause higher
pressure and, consequently, greater wear and tear of pump components. By loosening
both fastener screws, the sleeve support device on the mixture tube can be easily
disassembled in order to clean the chamber thoroughly.
- The dry material hopper only has to be cleaned when working with a different class of
dry material or when the machine is prepared for use during prolonged periods of
time.
7.3 Stoppage of the machine
If the Mini pump is not used for prolonged periods, e.g. during winter, we recommend
that you unscrew the sleeve rotor and perform the cleaning work described in the previous point.
In this way, sleeve contour deformations are avoided and the rotor is prevented from becoming
stuck.