UTIFORM Delta-Mini, Инструкция по эксплуатации

Страница: 11 / 62

Mini Pump 10
5 Start-up
5.1 Installation of the machine
The Mini pump must be installed on the flattest surface possible and secured by
activating the two wheel brakes. The compressor and driving motor connectors must be
connected to the electricity sockets supplied for this purpose on the electronic control panel.
There can be no confusion because the connecting sockets and cable lengths are different.
The main motor switch must be placed in the “0” position. The additional cleaning
connection and release valves on the water valves must also be closed. Also check that the
material stop valve is closed.
5.2 Electricity supply point
Use only a special three-pole 3*2.5 mm
2
section and 1 KV electricity cable for
construction work. In order to avoid voltage losses, the electricity cable must always be unreeled
completely!
To ensure proper operation of this machine, it is very important that the power supply is
230 V at the machine’s power supply inlet.
WARNING!
5.3 Water supply point
The water hose, which is resistant to creases and high pressures, must be completely
unreeled; it must have a minimum interior diameter of 3/4”. It must be connected to a suitable
tap and any air inside the hose must be eliminated. The water pressure gauge needle must
indicate a minimum pressure of 3.5 bars; this can be achieved by installing a pre-fitted pump to
increase water pressure between the water supply network and the machine.
5.4 Product hose placement and lubrication
The Mini pump is equipped with an original factory-supplied hose fitted with quick-
fitting couplings. The hose distance must be as short as possible. We recommend moistening or
lubricating the hose interior to prevent it from becoming blocked. To do so, a coupling is
connected to the machine to establish the hose cleaning connection; the hose is filled with water
and the water is allowed to run out of the end.
5.5 Connection of the air hose and spraying lance
Unreel the 3/8” air hose, which is resistant to pressure and creases, next to the product
hose and connect it to the machine air outlet. When this is done, the compressor hose must be
connected to the air pressure gauge and the connection plug to the corresponding electricity
socket on the electronic control panel. The spraying lance is connected to the other end of the air
hose and the air spray gun is adjusted (the diameter of the product hose nozzle is equal to the
distance of the air gun on the spraying lance).
5.6 Checking the rotation direction
- Lower the head motor and remove the beater. Put the motor back in its vertical
position.
- Disconnect the water hose from the mixing tube.
- Activate the head motor, compressor and, finally, main switch (red and yellow).
- The motor must rotate in the direction indicated by the arrow on the protective part of
the motor fan (anti-clockwise, i.e. to the left).